Aircraft Enters Unresponsive Hover State During Autonomous Operation
Prevent the XAG P150 Max from entering an unresponsive hover state and losing remote communication by updating the System Service firmware.
Release Date: 2026.05.15 Mitigation Type: Temporary
Current Status: Firmware Released & Monitoring Ongoing
System Service firmware version 3.2.0.40 has been released to target and mitigate the issue during autonomous operation.
Required Operator Actions
Operators are advised to:
! Update all aircraft firmware to the latest available version,
! Verify successful firmware installation before operation,
! Maintain continuous visual observation during autonomous missions.
If abnormal hover behaviour or communication loss is observed:
! Immediately suspend operation where possible,
! Maintain safe separation from the aircraft,
! Document the occurrence for technical investigation.
Following any occurrence:
1. Follow the XAG Australia Post-Incident Reporting Guide
2. Submit a warranty assessment request via: XAG Australia Warranty Service Request Form
Instructions for Pilots
1. Update aircraft firmware via: XAG One App → Me → Device → P150 Max Device Details → Firmware Update
2. After completing the firmware update:
! restart the aircraft,
! restart the remote controller,
! and confirm all onboard servicesinitialise correctly.
3. Conduct a low-risk validation flight before resuming normal operation.
If similar behaviour is observed after theupdate, immediately submit a technical support request via: XAG Australia Repair Request Form
